Info van Sparkfun website over de nieuwe Arduino Due met ARM 32 bit CPU:
Because of the limitations of system voltage imposed by the Atmel SAM3X8E, Arduino shields that are based on the 5v models won't work properly. All the shields that fully implement the Arduino R3 layout are compatible straight away (like the Arduino WiFi shield and Ethernet Shield) but other shields might not be compatible. Be careful when you're plugging stuff in!
Note: Unlike other Arduino boards, the Arduino Due board runs at 3.3V. The maximum voltage that the I/O pins can tolerate is 3.3V. Providing higher voltages, like 5V to an I/O pin could damage the board.
Het plaatsen van een Nodo Shield op dit bord lijkt mechanisch geen probleem, maar het zal waarschijnlijk niet gaan werken. Het bord levert wel 5 volt via de headers, dus als het shield deze pin gebruikt voor de eigen VCC aansluiting, zal ook 5 volt worden gebruikt voor IO. Dan vrees ik het ergste voor de chip...