nodo-domotica.nl

Wiznet W5500 Ondersteuning ?

Hier alles over de hardware kant van de Nodo

Wiznet W5500 Ondersteuning ?

Berichtdoor bunny007 » 30 jan 2016, 12:01

Iemand ervaring met de "nieuwe" Wiznet W5500 ethernet shields ?
lijkt me wel een upgrade voor de nodo;

• Supports following Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
• Supports 8 independent sockets simultaneously
• Supports Power down mode
• Supports Wake on LAN over UDP
• Supports High Speed Serial Peripheral Interface (SPI MODE 0, 3)
• Internal 32Kbytes Memory for Tx/Rx Buffers
• 10BaseT/100BaseTX Ethernet PHY embedded
• Support Auto Negotiation (Full and half duplex, 10 and 100-based)
• Not support IP Fragmentation
• 3.3V operation with 5V I/O signal tolerance
• LED outputs (Full/Half duplex, Link, Speed, Active)
• 48 Pin LQFP Lead-Free Package (7x7mm, 0.5mm pitch)

Afbeelding

Ref : http://www.ebay.com/itm/W5500-Network-Expansion-Board-SPI-to-Ethernet-Shield-Replace-W5100-For-Arduino-/181924162842?hash=item2a5b866d1a:g:H7MAAOSwwbdWQGSQ

Ref : http://www.shopwiznet.com/w5500
R744, Mega, LAN, Nodoshield v1.2, 1xDHT22, 5xDS18B20, 5x8ch relay, 40/8p PCF8574, 5xKAKU, 4x2262, RFID
R744, Mega, LAN, 2xDS18B20, 2x8ch relay, 16/8p PCF8574, 2xHC-SR501
R818, MiniPro, 433RF, 2xMG995 Servo
Orange PI PC (€15) - Lubuntu 14.04 - Domoticz
bunny007
 
Berichten: 129
Geregistreerd: 09 dec 2011, 08:46

Keer terug naar Nodo Hardware

Wie is er online?

Gebruikers in dit forum: Geen geregistreerde gebruikers. en 1 gast