Hallo Mark,
Ik vond hier :
het volgende bij de commentaren ...
If uploading sketches using the Arduino IDE and selecting the corresponding Pro Mini board fails, follow these steps to update the bootloader: 1. Prepare an Arduino Uno, Mega or similar to act as ISP as described at
http://arduino.cc/en/Tutorial/ArduinoISP 2. Wire it up as shown in the wiring diagram posted above 3. Use Arduino IDE to flash the bootloader of the corresponding Pro/Pro Mini (5V, 16MHz) to SKU099688 or SKU066315 I use six pinheader pins on breadboard and a clamp to ensure good contact between the pins and the holes. This way I do not have to solder pin headers.
Daar vond ik deze programmer ...
Persoonlijk heb ik goede ervaringen met deze leverancier. Alles komt netjes aan. Je moet wel wat geduld hebben. Het langst dat ik heb moeten wachten is 21 werkdagen, het kortst 16 dagen.
Patrick